4 MAINTENANCE
GB-14
4.3 ENGINE OIL ______________________________________________________________
Check the engine oil at the start of each day, before starting
the engine. If the oil level is low, remove oil filler cap and add
oil as required.
Perform initial oil change after the first 20 hours of operation.
Change oil every 100 hours thereafter.
See the engine manufacturer’s Owners’s Manual for
detailed service information.
After adding or changing oil, start and run engine at idle with
all drives disengaged for 30 seconds. Shut engine off. Wait
30 seconds and check oil level. Add oil to bring up to FULL
mark on dipstick.
Use only SAE 10W30 engine oils with API classification
SG.SF/CC.CD
Figure 4A
4.4 TIRES ___________________________________________________________________
1. Keep tires properly inflated to prolong tire life. Check
pressure only when the tires are cool.
2. Use an accurate, low pressure tire gauge. 6 - 8 psi
(41.3-551. kPa)
4.5 WHEEL BEARING _________________________________________________________
The bearing has the word
LOCK
and an arrow stamped
on the face. When replacing the bearing, make
absolutely certain that the bearing is being installed in
the proper direction or rotation.
For the
Right
wheel, install the bearing with the
“
LOCK
➨
" arrow to the
Outside
of the bearing housing.
For the
Left
wheel, install the bearing with the “
LOCK
➨
"
arrow to the
Inside
of the housing.
Figure 4B
Upper Oil Level
Oil Filler Cap
CAUTION:
Unless you have the proper
training, tools and experience, DO NOT
attempt to mount a tire on a rim. Improper
mounting can produce an explosion that may
result in serious injury.
To Next Page
Loading...
Need help?
General
