ISEKI LAWN MOWERS
1
This service manual has been prepared to provide the information and suggestions necessary
for servicing the ISEKI SXG Lawn Mower. These include construction, specifications, removal
and reinstallation of the components, disassembly and reassembly instructions, inspection and
adjustment instructions, troubleshooting, general precautions etc.
Figures mentioned in this manual are standard values established by ISEKI for the SXG,
consequently when a non-ISEKI part has been installed on the machine or adjustments and
repairs have been made in a manner other than as specified in this manual, the pertinent values
mentioned herein are no longer valid. ISEKI does not assume responsibility for problems or
damage caused by a value deviation due to maladjustment or by the use of unauthorized parts.
Servicing procedures outlined in the manual contain sufficient information to return all
component parts of a machine to new condition. In discussion of each component part, it is
assumed that a complete overhaul is being performed, consequently, complete disassembly and
reassembly are outlined. The machine is relied upon to decide how far disassembly must be
carried out when complete overhaul is not required.
Study unfamiliar service procedures thoroughly and understand them clearly before attempting
disassembly. Specific data essential for proper overhaul, such as running clearances and torque
values, have been provided in interline of inspection and reassembling procedures of each
group section.
This manual was compiled from latest information available at time of publication, However
ISEKI reserves the right to make changes at any time without notice.
Whenever the terms “left” and“ right” are used, this means as viewed by the operator when
seated in the operator’s seat.
Whenever servicing the machines, pay sufficient attention to the operational safety to protect you
and other persons around the machines from danger by following carefully the instructions given
in the manual. Never take chances!
FOREWORD