10
5.5 CLEARRAY Program
• To make changes to the CLEARRAY bulb replacement timer or to reset it , follow the steps below
to access the program.
Menu button Action Result
Press 3x
To access the CLEARRAY Menu. The LED will display “U.”
Press once
Activates the system for changes. Either zero or the remaining number
of days will display.
Press once
To access the UV bulb replacement timer. The number of days on the
display will blink once.
or
Press
Increases or decreases the number of days in increments of 10 except
for the last selection that is a 5-day increment.
Press once
The new selection will blink twice on the display to conrm your selec-
tion.
5.6 Economy Mode
• Follow the steps below to access the program.
• In Economy mode, the heater only activates after a Secondary Filtration cycle has nished. The
heater will run for a maximum of 30 minutes.
• The heater can turn off prior to the 30 minutes if the programmed water temperature is reached.
• The Secondary Filtration program determines the number of cycles (from 1 to 4) that the heater
will be allowed to activate.
For example, if you have programmed the SF3 setting (10 minutes of ltration every 6 hours), then
the heater will run, for a maximum of 30 minutes, after the end of each of the 10-minute secondary
ltration cycle, for up to four times per day.
Menu button Action Result
Press 4x
To access the Economy Mode Menu. The LED will display “ECO.”
Press once
Activates the system for changes. Current programmed mode blinks
once on the display.
or
Press
Toggles between: , or
Press once
The new program will blink twice on the display to conrm your selec-
tion.
CYCLE RUN TIME HEATER RUN TIME
No ltration Maximum of a half hour per day
10 minutes of ltration every 12 hrs
Maximum of a half hour every 12 hrs (after sec-
ondary cycle ends)
10 minutes of ltration every 8 hrs
Maximum of a half hour every 8 hrs (after sec-
ondary cycle ends)
10 minutes of ltration every 6 hrs
Maximum of a half hour every 6 hrs (after sec-
ondary cycle ends)