Janome Continental M7 Professional - Getting Ready to Sew; Connecting Power Supply

8
Changing the printed circuit board F and slide volume
Printed circuit board F
To remove:
1. Remove the front cover. (Refer to page 4)
2. Disconnect the connector for printed circuit board F.
3. Remove the setscrews A (3 pcs.) and reomve the
printed circuit board F.
To attach:
1. Follow the steps of removal procedure in reverse.
Printed circuit board F
Printed circuit board F
Slide volume
Slide volume
To remove:
1. Remove the front cover. (Refer to page 4)
2. Remove the snap rings CS-3 (2 pcs.) and remove the
slide volume.
To attach:
1. Follow the steps of removal procedure in reverse.
* Insert the projection of slide volume into the
convex of speed control slider and x it with the
snap rings (indicated by the arrow).
Setscrew A
Snap ring CS-3
Connector for printed
circuit board F