40
Presser foot lifter stopper position (2)
The distance between the presser foot spring release base and the presser foot lifter
should be in the range of 39.4 mm to 39.8 mm when the presser foot is raised with the
presser foot lifter.
To adjust:
1. Turn the power switch on. Press the presser foot lifter
button to lower the presser foot.
Turn the power switch off.
2. Turn the handwheel toward you to lower the needle.
Raise the presser foot lifter.
Loosen the hexagonal socket screw of the presser
foot lifter stopper from the front side of the machine.
3. Adjust the distance between the presser foot spring
release base and the presser foot lifter stopper to
39.6 mm.
Tighten the hexagonal socket screw.
4. Check the needle threader hook position. (Refer to
page 24)
Presser foot lifter
stopper
Front side of the machine
Needle bar
Hexagonal socket
screw
Presser foot lifter stopper
Presser foot spring
release base
39.4 to 39.8 mm
To Next Page
Loading...
