Janome Continental M7 Professional - Ordinary Sewing Mode Details; Monogramming, Tapering, Hand Stitch Styles; Sewing Applications Overview

33
To attach lower shaft
When you replace the lower shaft or the lower shaft parts, adjust the phases as shown
below.
The phases of the thread drawing lever cam (A) and the feed cam (B) are the same as that
of the spring pin (C).
The phase of feed lifting pin (D) is shown below.
Lower shaft gear
Feed cam
Thread drawing
lever cam
Lower shaft gear
Feed lifting pin (D)
Feed lifting cam
(A)
(B)
(C)
Spring pin 3x18
X
View from "X"
Lower shaft gear
alignment mark
Lower shaft gear
spring pin
Feed lifting pin (D)
Phase of the feed lifting pin (D)