Janome Continental M7 Professional - Front Cover

4
To remove:
1. Remove the face plate, top cover and belt cover.
(Refer to pages 1 and 2)
2. Loosen the setscrews A (5 pcs.).
3. Remove the setscrews B (2 pcs.).
4. Disconnect the printed circuit board U2 exible cable,
the printed circuit board L1 connectors (2 pcs.),
the printed circuit board F connector, the slide volume
connector and the rotary encoder connector.
Remove the front cover.
To attach:
1. Follow the steps of removal procedure in reverse.
Changing external parts (4)
Front cover
Printed circuit board U2 exible cable
Slide volume connector
Printed circuit board F connector
Rotary encoder connector
Setscrew A
Setscrew A
Setscrew A
Setscrew A
Setscrew A
Setscrew B
Printed circuit board L1 connector