Janome Continental M7 Professional - Variety of Straight Stitches; U1-U5 Straight Stitch Types; U6, U7 Stretch Stitches

38
Stretch stitch feed balance adjustment
1. Attach the satin stitch foot F.
2. Set the stretch stitch feed balance dial to the neutral
position.
3. Turn the power switch on while pressing the start/stop
button and reverse button to enter the factory setting
mode.
4. Press the “8 Adjust” key to select the “8 Adjust mode”.
5. Start the machine and sew at the maximum speed
until it stops automatically.
The machine sews 8 of number 8 and stops
automatically. Measure the length of 5 (from the third
to the seventh) of 8.
(The length 5 of 8 should be 33 mm to 39 mm.)
Stretch stitch balance dial position:
1. Remove the base cap.
2. Sew 8 of number 8.
3. If the length is longer than 39 mm, turn the adjusting
screw in the direction of (A).
If the length is shorter than 33 mm, turn the adjusting
screw in the direction of (B).
4. Sew 8 of number 8.
5. Attach the base cap.
Stretch stitch balance dial
Base cap
Turn the
adjusting
screw in the
direction of (B).
Adjusting screw
33 to
39 mm
Stretch stitch balance dial position
Neutral position
(A) (B)
Turn the
adjusting
screw in the
direction of (A).
Bottom of the base
CorrectIncorrect Incorrect
Reverse button
Start/stop button