Janome Continental M7 Professional - Overcasting Stitch Variety; U11-U17 Overcasting Stitch Types

43
Presser bar lifter switch position
To check:
1. Attach the zigzag foot (A) .
2. Turn the power switch on while pressing the start/stop
button and reverse button to enter the factory setting
mode.
Press “Foot Sensor” key to select the foot sensor
adjusting mode.
3. Press the presser foot lifter button to lower the presser
foot.
Raise the presser foot slowly by raising the presser
foot lifter.
The distance between the lower part of the presser
foot and the surface of needle plate should be 4.5
mm to 5.5 mm when the indication below “Switch”
changes to “H” from “L”. If not, adjust as follows;
To adjust:
1. Remove the face plate and rear cover (Refer to
pages 1 to 5).
2. Loosen the setscrews of micro switch set plate.
3. Place the 5 mm block (spacer) between the presser
foot and the needle plate, and lower the presser foot.
4. Raise the presser foot lifter lightly as possible from its
lowest position. Stop the presser foot lifter at the point
where the lifter start to raise the presser foot.
Fix the presser foot lifter with a sticky tape at that
position.
5. Lower the presser foot lifter switch little by little, and
stop it when the “Switch” changes to “L” from “H”.
Tighten the setscrews.
6. Remove the 5 mm block (spacer). Remove the sticky
tape and lower the presser foot lifter.
Raise the presser foot lifter slowly. “Switch” changes
to “H” from “L” when the distance between the lower
part of the presser foot and the surface of the needle
plate is 4.5 to 5.5 mm.
Setscrew
4.5 to
5.5 mm
Presser foot lifter
Presser foot
lifter switch
Micro switch setting plate
Surface of
the needle
plate
Reverse button
Start/stop button