Janome Continental M7 Professional - Replacing the Presser Foot; Presser Foot Replacement Procedure

18
Height and direction of presser bar adjustment
The clearance between the presser foot and the surface of the needle plate should be 6.0
mm when the presser foot is raised with the presser foot lifter.
The presser foot should be parallel to the slot of the feed dog teeth when attached.
1. Attach the zigzag foot A.
2. Remove the face plate. (Refer to page 1)
3 . Turn the power switch ON while pressing the start/
stop button and the reverse stitch button to enter the
factory setting mode.
Press the “Feed Dog” key to select the feed dog
adjusting mode.
4. Press the drop feed key to drop the feed dog.
Press the presser foot lifter button to lower the
presser foot.
5. Raise the presser foot lifter lever.
6. Loosen the setscrew on the presser bar supporter to
adjust the presser foot direction so that the slot for the
feed dog teeth and the zigzag foot should be parallel.
7. Place a 6 mm block between the presser foot and the
needle plate.
Tighten the setscrew holding the presser foot against
the block.
Setscrew
(2 mm width
across ats)
Presser
foot
Presser bar
supporter
Drop feed key
Needle plate
Needle plate
Approximately
6.0 mm
Block
Presser foot lifter lever
Setscrew
Slot
Should be
parallel
Reverse button
Start/stop button
Presser foot lifter button
Approximately
6.0 mm