Janome MC300E - Adjusting Needle Drop Position

8
MC300E
Adjusting Needle Drop Position
1 Lower the Needle to its lowest position by turning
the handwheel.
2 Remove the face cover and loosen Screw ,
move the Needle bar supporter to the right or
left until the needle comes to the center of the
Needle plate hole .
3 Tighten the Screw .
4 Attach the face cover.
Screw
Needle bar supporter
Needle
Nedle plate hole
2
1
4
3
2
1
3
4
1
2
3
4
1
The needle should be positioned in the center of needle plate hole.
3