Janome MC300E - Adjusting Needle Thread Tension

14
MC300E
Adjusting Needle Thread Tension
The standard upper thread tension should be 51 to 59 grams when the tension dial
is set at “3”, measured with a #50 polyester thread being pulled at approximately 110
mm/sec. in the direction of arrow.
1 Set the Thread tension dial at “3”.
2 Lower the presser foot.
3 Remove the front cover unit and adjust the thread
tension.
(A) If the thread tension is more than 59 g
.................turn the screw in the direction of “B”.
(B) If the thread tension is less than 51 g
...............turn the screw in the direction of “A”
Pulling direction: (Pulling speed 110 mm/ Sec.)
4 Attach the front cover unit.
(A)
(B)
1
1