Janome MC300E - Adjusting Solenoid

23
MC300E
Adjusting Solenoid
1. Remove the front cover. (See page 6)
2. Loosen Screws (2 pieces).
3. Slide the Solenoid to the right most position.
4 Tighten Screws .
5 To check tension release function
a.Turn the power switch “ON” while pressing the
Start/Stop button. Touch panel indicates the Self
Check function keys as shown.
c. Press the “Solenoid” key on the touch panel and it
will indicate Solenoid “Key”.
d. Press the Solenoid “Key” several times to check if
the Tension disc and Tension disc holder
open when the solenoid is activated.
e. Press “OK” key.
f. Attach the front cover.
Note: Do not touch the Self Check function keys
other than the “Solenoid”.
1
3
Screw (A)
Solenoid
Tension disc
Tension disc holder
Plunger
Slide to the right.
6
1
2
4
2
1
1
2
3
4
5
6
5
3
4