Janome Memory Craft 15000 - Special Bobbin Holder for Embroidery; Bobbin Winding While Working on an Embroidery Project

109
x Insertthespecialbobbinholderintothehookrace.
Make sure to match the knob of the bobbin holder
with the stopper on the machine.
Attach the needle plate.
e Knob
r Stopper
t Special bobbin holder for embroidery
NOTE:
Use the standard bobbin holder when sewing lace
designs and quilting designs that use the same thread
for the bobbin as the needle thread.
Special Bobbin Holder for Embroidery
Replace the standard bobbin holder with the special
bobbin holder for embroidery when using bobbin threads
other than Janome bobbin thread for embroidery.
NOTE:
The special bobbin holder is marked with a yellow dot
for identification.
q Yellow dot
w
r
e
z Remove the needle plate (refer to the previous page).
Take out the standard bobbin holder.
w Standard bobbin holder
z
x
t
q
Bobbin Winding While Working on an
Embroidery Project
You can wind a bobbin while running the machine.
To set the additional spool pin, please refer to page 12.
Draw the thread to the left and forward around the thread
guide e.
Draw the thread to the rear and to the right around and
under the guide plate r.
Firmly pull the thread to the right.
Follow the procedure from c to , of page 13 to wind the
bobbin.
q Spool stand
w Spool
e Thread guide
r Guide plate
q w
e
r