127
Attach the hoop to the carriage and press the trace key.
Press the key to select trace and baste (single) (refer
to page 122).
Start the machine to mark around embroidery design
with basting stitches.
Cut the applique fabric the same size as the marked
area.
Place the applique piece on the marked area and sew
the first section (color).
NOTE:
Pin the applique piece or use spray adhesive to fix it
in place as necessary.
Applique Designs
Fringe designs SQ14-265 and SQ14-266 are special
designs for machine embroidery applique.
You can attach applique piece to background fabric and
embroider applique design at the same time.
Example: Fringe design SQ14-265
Prepare background fabric and applique fabric.
Select fringe design SQ14-265, and set the background
fabric to the hoop.
Remove the hoop from the machine, but do not unhoop
the fabric.
Remove the basting stitches. Cut away the excess
applique fabric as close to the seam line as possible.
Attach the hoop to the machine again.
Sew the remaining sections (colors) of the applique
design.
To Next Page
Loading...
