Janome Memory Craft 15000 - Cloth Guide

The visual touch screen will show a warning message.
Press the OK key.
The cloth guide adjustment window will open.
Press the or key to move the cloth guide to
the desired position.
The cloth guide will move the distance indicated on the
key.
The cloth guide position is indicated on the scale bar
and the distance from the center needle drop position is
indicated in millimeters or inches.
Press the OK key to register the setting and close the
cloth guide adjustment window.
NOTE:
The machine will not run if the cloth guide adjustment
window is open.
Press the default key to return the cloth guide to the
default position (15 mm or 5/8˝).
y Default key
Make sure to return the carriage to the stored position
by pressing the cloth guide storage key and remove the
cloth guide after you finish sewing.
u Cloth guide storage key
Cloth Guide
CAUTION:
•Alwaysleavesufcientspacetotheleftofthe
machine when using the cloth guide.
•Donotusetheclothguidewhenthebuttonhole
foot R is attached.
•Theextensiontablecannotbeopenedwhenthe
cloth guide is in use.
Attaching the cloth guide
Attach the embroidery unit (see page 104).
Insert the pin on the cloth guide into the carriage hole.
Turn the attaching knob clockwise to secure the cloth
guide.
q Pin
w Cloth guide
e Carriage hole
r Attaching knob
Setting the cloth guide position
Press the cloth guide key.
t Cloth guide key
u y
r
q
e
w
t
40