Janome Memory Craft 15000 - Troubleshooting (Automatic Needle Threader)

162
Troubleshooting (automatic needle threader)
Iftheautomaticneedlethreaderstuckandwillnotreturn
to the up position automatically, correct it as follows:
Carefully turn the handwheel away from you or toward
you to move the needle up a little.The automatic needle
threader will return to the up position automatically.
Iftheautomaticneedlethreaderstilldoesnotreturnto
the up position, follow the procedure below.
z Turn the power switch off.
Open the face plate.
x Lift the shaft plate with your finger as far as it goes.
z
x
c
c Close the face plate.
Turn the power switch on.