Janome Memory Craft 15000 - Adjust Key; Auto Thread Tension Level; Cutting the Tails of Jump Threads; Embroidery Foot Height

123
•Embroideryfootheight
Press one of the fabric icon keys to select the
recommended height or press the “+” or “–” key to fine
tune the foot height.
w Plain fabric key
e Quilting key
Press the OK key to activate the new settings.
To return to the default settings, press the default key.
r Default key
•Cuttingthetailsofjumpthreads
This option is can be used when the “jump thread cutting
length” setting or “cutting command“ is activated (refer to
page 153).
Press the “+” or “–” key to adjust the tail length of jump
thread.
Adjust Key
Press the adjust key to open the manual setting window.
You can adjust the following settings in this window.
q Adjust key
q
t
•Autothreadtensionlevel
Press the “+” or “–” key to adjust the thread tension to
your preference.
w e
r
Embroidery mode key
Press this key to open the embroidery mode window.
t Embroidery mode key