Janome Memory Craft 15000 - Automatic Needle Threader

v Pull the thread loop r to take the thread end out
through the needle eye to the rear.
r Thread loop
NOTE:
•Theautomaticneedlethreadercannotbeused
with the twin needle.
•Ifthethreadiscaughtinthehookandthethread
loop is not formed, remove the thread from the
hook and pull it to take the thread end out through
the needle eye.
Automatic Needle Threader
NOTE:
The needle threader can be used with a #11 to #16
needle.
Thread size 50 to 90 is recommended.
Do not use thread size 30 or thicker.
Make sure the machine is locked out.
z Draw the thread through the slit q of the needle
threader. The thread should pass under the hook w.
q Slit
w Hook
z
x
c
v
q
x Pull the thread up and slip it between the thread cutter
and face plate from behind.
Pull the thread toward you to cut.
c Press the needle threader button e.
The needle thread will be automatically threaded to
the needle eye.
e Needle threader button
e
r
w
16