142
3. When the fresh water tank is full, set the valves to the
setting. Turn the pump ON to send water through the lines.
4. Run water through all faucets (hot and cold, including outside show-
er and outside kitchen) until chlorine smell is gone. Turn all faucets
and outside shower o, turn pump OFF.
5. Drain the fresh water system again. If the RV has the full system
canister water lter, remove the canister, reinstall the lter, and reattach the canister.
6. Rell the fresh water tank with fresh water again and when water heater is full of water,
turn the water heater power ON. Water heater is full if you open a water faucet
and water comes out in a steady stream.
If a chlorine taste lingers in the water,
ush the water system with a solution consisting of one-quart vinegar
to ve gallons of clean water. Re-ush as necessary. The vinegar
solution may damage the water heater or the water lter. Remove the
canister water lter and bypass the water heater.
(pointing up).
Follow the steps outlined in Draining the Fresh Water System with
one exception:
For the water lter: remove the canister, take out
the lter, then re-attach the empty canister.
1. For a tank type (storage) water heater, the power should still be OFF (both electric and
LP Gas switches).
2. Put the vinegar solution into the fresh water tank.
Set the colored valves to the setting.
Green valve points left
Blue valve points down
Attach a short hose to the SANITIZE/WINTERIZE inlet. Put the other end of the hose
in a container with the vinegar solution. Do use your fresh water hose for this.
Turn the water pump ON. The solution will be drawn into the fresh water tank When
the container is empty, turn pump OFF, and disconnect hose from utility panel.
To aid in siphoning, place the container approximately (2) feet o the ground. The
drain valves must be closed.
3. Fill the fresh water tank full of clean (potable) water. Use water either from a pressur-
ized source, or from a container (as detailed in Step 18).
4. Set the valves to the setting. Turn the pump ON to
send water through the lines. Run water through all faucets (hot and
cold, including outside shower and outside kitchen if applicable)
until chlorine smell is gone.
5. Close all faucets including outside shower and outside kitchen (if
applicable). Turn pump OFF.
6. Drain the system again, but do not drain the water heater (water heater power still OFF
and water heater is bypassed).
7. Close low point drains and fresh water tank drain.
8. Rell the fresh water tank with clean potable water. Use the CITY WATER CONNEC-
TION inlet or SANITIZE/WINTERIZE inlet depending on which ll method you use
explained in Step 18 previously.
To Next Page
Loading...
