63
Keep your awnings clean and in good condition to prevent costly repairs.
Periodically check that the fasteners are tight. Tighten if necessary.
Keep the awning fabric clean. For detailed cleaning information, refer to the
manufacturer’s owner information.
Your recreation vehicle may include one or more of the following options:
Power window awning
Slide out awnings
Power awning over entrance door
Power switches to operate the awnings are typically found in the control panel above the
entrance door or if your RV has a touchscreen, the awning controls may be located there.
Some patio awnings are equipped with a motion detector. If the patio awning experiences
extreme or excessive movement, it will automatically retract to the travel mode position.
For detailed safety and operating information, refer to the manufacturer’s user guide.
– refer to the manufacturer’s owner manual which is located on both a
CD and a USB ash drive included in your warranty packet. This CD (or ash drive) will
include several dierent awning manuals including slide out toppers and patio awnings.
Included also is troubleshooting, service and repair information. Follow all safety related
warnings and information included in the manuals.
The electric awning requires connection to a 120-volt power
source. Make sure you have sufcient power available before operat-
ing your awning (refer to Electrical Systems, Calculating electrical
load)***Certain awnings (Reatta, Reatta XL & Embark) require a 12VDC
power source..
To Next Page
Loading...
