91
• STATUS LED FLASHES AMBER, DISPLAY LED IS OFF - If the unit is in In-
verter Mode, and you plug in shore power, the STATUS LED will begin ashing
AMBER and the unit will switch to Bypass Mode within 20 seconds of detecting
an AC input.
• If the STATUS LED is RED and DISPLAY LED is OFF, the display will show an
error code of E01 through E12. This indicates a fault in the inverter circuit that
needs attention. Inverter will shut down.
Refer to the Magnum Inverter manufacturers’ manual in your
warranty packet for further operating instructions, error codes,
changing inverter settings and safety information.
The power button is a power disconnect switch and will
not remove DC power from the inverter. Disconnect power from the
inverter before working on it.
Command Control System (If So Equipped)
The Command Control System is a name given to encompass several dierent types of
Bluetooth controlled systems now being used in Jayco and Highland Ridge towable RVs.
Examples of Bluetooth controlled systems currently in use are listed below.
The Command Control System is capable of controlling some or all of the following features
depending on the Bluetooth system and RV model:
RV Auto Leveling System Power Jacks and Stabilizers
Interior and Exterior Lighting RV Slide out rooms
Power awnings Generator
TV and bed lifts HVAC thermostat
Gas and Electric water heaters Water tank levels (Blk, Gry, Fresh)
Battery levels Back up camera sysems
Water Pump Kitchen & bath vents and covers
Door locks TV, radio and DVD systems
Automatic Fireplace control Automatic ramp door (toyhauler)
Smartsense Propane Sensor Smarttemp Temperature Sensor
Current Bluetooth systems in use that fall under the Command Control System would in-
clude:
○ uses the LCI One Control App (for phone or tablet)
(Apple/Android)
○ uses the LCI One Control App (for phone or tablet
(Apple/Android)
To Next Page
Loading...
