18 - 2
Hydraclamp Valve
Dismantling and Assembly
The numerical sequence shown on the illustration is
intended as a guide to dismantling.
For assembly the sequence should be reversed.
When Dismantling
Plug hose 1 to prevent loss of oil and entry of dirt.
When Assembling
Note: View 'A' shows the clamp in the OFF position.
Ensure that orifice X is clear.
Lubricate new seals with Hydraulic Fluid.
Ensure that plug 7 locates in groove Y of rotary spool 9.
Torque nut 5 finger-tight before locking lever 4.
Ensure that spool 9 rotates freely after tightening nuts 5 and
3.
Torque Settings
Item Nm kgf m lbf ft
3 55 - 67 5.6 - 6.84 40.5 - 49.5
7 3.3 - 4.7 0.35 - 0.49 2.5 - 3.5
14 21.3 - 26.7 2.22 - 2.78 16 - 20
Section E Hydraulics
9803/8550
Section E
18 - 2
Issue 1
Valves
To Next Page
Loading...
