Section K - Engine
Engine Mounting
Moving the Engine
K-3 K-3
9803/9570-4
Engine Mounting
Moving the Engine
Sliding the Engine Backwards
The engine can be moved back on its mounting to enable
access to the loader pump, track motors and valve block
also the battery up to machine no. 1360211.
1 Remove the engine cover (if fitted).
2 Unscrew the two bolts A at the rear of the mounting
frame and the single bolt B underneath and at the
front of the mounting frame.
3 Pull the engine back as far as it will go.
Sliding the Engine Forwards
1 Push the engine fully forward.
2 Fit the two bolts A and tighten evenly to pull the
engine mounting forward to its secured position then
fit bolt B.
3 Refit the engine cover (if fitted).
Fig 1.
A
A
A
B
B
manualequipospesados@gmail.commanualequipospesados@gmail.com
To Next Page
Loading...
