Section C - Electrics
Switches
Ignition Switch
C-3 C-3
9803/9570-4
Switches
Ignition Switch
Yanmar Engine
Removal
1 Open the engine cover.
2 Disconnect the wiring at the connector.
3 Remove the switch mounting screws and withdraw
the switch A from the engine cover.
Fig 3.
Replacement
Replacement is a reversal of the removal sequence.
Lombardini Engine
Removal
1 Open the engine cover.
2 Disconnect the wiring at the connector.
3 Unscrew the two mounting bolts securing the ignition
switch assembly to the control tower. These are
located on the inside surface of the tower.
4 Withdraw the switch assembly B from the tower.
Fig 4.
Replacement
Replacement is a reversal of the removal sequence.
A
B
manualequipospesados@gmail.commanualequipospesados@gmail.com
To Next Page
Loading...
