Section 2 - Care and Safety
Safety Notices
Safety Checklist
2-8 2-8
9803/9570-4
2 Thoroughly wash contaminated area with
detergent and water.
3 Contain all removed material, gloves etc. used in
this operation in sealed plastic bags and dispose
of in accordance with Local Authority
Regulations.
DO NOT BURN FLUOROELASTOMERIC MATERIALS.
INT-3-3-5_3
!MWARNING
Protect your eyes when grinding metal. Wear safety
glasses or goggles. Remove or protect any
combustible materials from the area which could be
ignited by sparks.
GEN-1-12
!MWARNING
To avoid burning, wear protective gloves when
handling hot components. To protect your eyes, wear
goggles when using a wire brush to clean
components.
HYD-1-3
!MWARNING
Arc Welding
To prevent the possibility of damage to electronic
components, disconnect the battery and the alternator
before arc-welding on the machine or attached
implements.
If the machine is equipped with sensitive electrical
equipment, i.e. amplifier drivers, electronic control
units (E.C.U.s), monitor displays, etc., then disconnect
them before welding. Failure to disconnect the
sensitive electrical equipment could result in
irreparable damage to these components.
Parts of the machine are made from cast iron; welds
on cast iron can weaken the structure and break. Do
not weld cast iron. Do not connect the welder cable or
apply any weld to any part of the engine.
Always connect the welder earth (ground) cable to the
same component that is being welded, i.e. boom or
dipper, to avoid damage to pivot pins, bearings and
bushes. Attach the welder earth (ground) cable no
more than 0.6 metres (2 feet) from the part being
welded.
INT-3-1-15_2
!MWARNING
Asbestos
Asbestos dust can damage your lungs. Some engine
gaskets contain asbestos. Do not dismantle the
engine or exhaust system; get these jobs done by a
qualified person who has a copy of the engine service
manual.
5-1-6-1
manualequipospesados@gmail.commanualequipospesados@gmail.com
To Next Page
Loading...
Need help?
General
