184 – Programming Guide
Example :SOUR:FREQ:STOP? returns 1575.0
:SOURce:SWEEP:DELAY
Syntax :SOUR:SWEEP:DELAY <space><NRf>
Function Causes the source optics module to changes its internal delay setting to the
specified value. This value is used to set the delay in seconds between subsequent
sweeps.
Example :SOUR:SWEEP:DELAY 1.5
:SOURce:SWEEP:DELAY?
Syntax :SOUR:SWEEP:DELAY?
Function Causes the source optics module to output its internal variable used to control the
laser’s inter-sweep delay
Example :SOUR:SWEEP:START? returns 1.5
:SOURce:SWEEP:TIME
Syntax :SOUR:SWEEP:TIME <space><NRf>
Function Causes the source optics module to changes its internal rate setting to the
specified value. This value is used to set the rate, in seconds, for a laser sweep.
Example :SOUR:SWEEP:DELAY 1.5
:SOURce:SWEEP:TIME?
Syntax :SOUR:SWEEP:TIME?
Function Causes the source optics module to output its internal variable used to control the
laser’s sweep rate
Example :SOUR:SWEEP:TIME? returns 1.5
:SOURce:SWEEP:MODE
Syntax :SOUR:SWEEP:MODE<space><NRf>
Function Causes the source optics module to change its internal polarization mode setting to
the specified value. This value is used to determine the polarization mode
sequence.
Example :SOUR:SWEEP:MODE 0
:SOURce:SWEEP:MODE?
Syntax :SOUR:SWEEP:MODE?
Function Causes the source optics module to output its internal variable used to control the
laser’s polarization mode
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...