44 – Getting Started
Table 11: Minimum Hardware Requirements
Component Description
Processor 200 MHz Pentium
1
microprocessor
Operating System Microsoft Windows 95/98 or Windows NT
Memory 32 MB RAM
Storage 1 GB free hard disk space required, 2 GB recommended
Monitor SVGA, 38 cm (15 in), 1024 x 768 resolution required
Drives CD-ROM drive
1
Pentium is a registered trademark of Intel Corporation.
To install the software:
1. Restart the computer.
2. Ensure that the transmitter and receiver are connected and powered-on as described earlier
in the Connecting the Transmitter section.
3. Make sure the SOM is set to sweep in Polarization Mode 0 and press the Execute button on
the source optics module to start the transmitter and enable the receiver to process the
optical inputs to it.
4. Insert the SWS CD-ROM, which is packed in the receiver box, into the computer drive. From
the Windows Start menu, choose the Run option. The Run window appears.
5. Type d:\setup (if using drive d) and click the OK button. The SWS software is installed on
the computer.
6. Follow the steps of the installation program until it brings you to the SWS Testing and Setup
Wizard.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...