EasyManua.ls Logo

Jeep Gladiator 2021 - Oil Life Reset - if Equipped; Off Road+ Display - if Equipped

Jeep Gladiator 2021
484 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
116 GETTING TO KNOW YOUR INSTRUMENT PANEL
Left And Right Arrow Buttons:
Using the left
or right arrow button allow
you to cycle through the submenu screens of
th
e Main menu item.
OK Button
Push the OK
button to access/select the
information screens or submenu screens of a
main menu item. To reset displayed/selected
features push and hold the OK button for two
seconds.
The Main Menu items consist of the following:
Speedometer
Vehicle Info
Off Road — If Equipped
Driver Assist — If Equipped
Fuel Economy
Trip Info
Stop/Start — If Equipped
Audio
Messages
Screen Setup
OIL LIFE RESET IF EQUIPPED
Your vehicle may be equipped with an engine oil
change indicator system. The “Oil Change
Required” message will display in the
instrument cluster display for five seconds after
a single chime has sounded to indicate the next
scheduled oil change interval. The engine oil
change indicator system is duty cycle based,
which means the engine oil change interval may
fluctuate, dependent upon your personal
driving style.
Unless reset, this message will continue to
di
splay each time you place the ignition in the
ON/RUN position. To turn off the message
temporarily, push and release the OK button. To
reset the oil change indicator system (after
performing the scheduled maintenance), refer
to the following procedure.
Oil Life Reset
1. Without pushing the brake pedal, place the
i
gnition in the ON/RUN mode (do not start
the engine).
2. Navigate to "Oil Life" submenu in "Vehicle
I
nfo" in the instrument cluster display.
3. Push and hold the O
K button until the gauge
resets to 100%.
Secondary Method For Oil Change Reset
Pr
ocedure
1. Without pushing the brake pedal, place the
i
gnition in the ON/RUN position (do not
start the engine).
2. Fully press the accelerator pedal, slowly,
t
hree times within ten seconds.
3. Without pushing the brake pedal, place the
i
gnition in the OFF/LOCK position.
NOTE:
If the indicator message illuminates when you
st
art the vehicle, the oil change indicator
system did not reset. If necessary, repeat this
procedure.
OFF ROAD+ DISPLAY IF EQUIPPED
When the Off Road+ button is pushed in the
switch bank, the Instrument Cluster Display will
begin to show messages related to the feature.
Depending on the Four Wheel Drive mode in
use, the messages will differ, and after five

Table of Contents

Related product manuals