94 GETTING TO KNOW YOUR VEHICLE
4. Unfold the outer flap and zip the hard top
bag closed.
Step Four
5. Store the Freedom Top panels bag in a safe
l
ocation.
HARD TOP FRONT PANEL(S)
I
NSTALLATION
1. Set the right side panel on the windshield
frame with the locating pin in the front
receiver mounting hole, followed by the left
side panel, making sure there is no
overhang. Make sure that the panels are
sitting flush with the body.
2. Secure the panel(s) using the same steps
f
or removal in reverse order.
NOTE:
To prevent water leaks, the seals and hard top
pa
nels should be clear of any dust and debris
prior to reinstallation.
REMOVING THE HARD TOP
Use this QR code to access your
digital experience.
1. Remove both front panels
Ú
page 91.
2. Open both front doors.
3
. Using the provided #50
Torx head driver
an d ratchet, remove the two Torx head
screws that secure the hard top at the
B-pillar (near the top of the front doors).
Step Three
4. If equipped, remove the lower interior soft
t
rim panel (attached by the hook-and-loop
fastener) by pulling the panel away from the
trim.
Step Four
To Next Page
Loading...
