SAFETY 313
NOTE:
In a parking lot situation, oncoming vehicles can
be
obscured by vehicles parked on either side.
If the sensors are blocked by other structures or
vehicles, the system will not be able to alert the
driver.
Blind Spot Modes
Blind Spot has three selectable modes of
operation that are available in the Uconnect
system.
Blind Spot Alert Lights Only
When operating in Blind Spot Alert mode, the
BS
M system will provide a visual alert in the
appropriate side view mirror based on a
detected object. However, when the system is
operating in Rear Cross Path (RCP) mode, the
system will respond with both visual and
audible alerts when a detected object is
present. Whenever an audible alert is
requested, the radio is muted.
Blind Spot Alert Lights/Chime
When operating in Blind Spot Alert Lights/
Ch
ime mode, the BSM system will provide a
visual alert in the appropriate side view mirror
based on a detected object. If the turn signal is
then activated, and it corresponds to an alert
present on that side of the vehicle, an audible
chime will also be sounded. Whenever a turn
signal and detected object are present on the
same side at the same time, both the visual and
audible alerts will be issued. In addition to the
audible alert, the radio (if on) will also be muted.
NOTE:
Whenever an audible alert is requested by the
BS
M system, the radio is also muted.
When the system is in RCP mode, the system
sh
all respond with both visual and audible
alerts when a detected object is present.
Whenever an audible alert is requested, the
radio is also muted. The RCP state always
requests the chime.
Blind Spot Alert Off
When the BSM system is turned off there will be
no
visual or audible alerts from either the BSM
or RCP systems.
NOTE:
The BSM system will store the current operating
mo
de when the vehicle is shut off. Each time
the vehicle is started the previously stored
mode will be recalled and used.
FORWARD COLLISION WARNING (FCW)
W
ITH MITIGATION — IF EQUIPPED
FCW with Mitigation provides the driver with
audible warnings, visual warnings (within the
instrument cluster display), and may apply a
brake jerk to warn the driver when it detects a
potential frontal collision. The warnings and
limited braking are intended to provide the
driver with enough time to react, avoid or
mitigate the potential collision.
WARNING!
Rear Cross Path Detection (RCP) is not a
backup aid system. It is intended to be used
to help a driver detect an oncoming vehicle in
a parking lot situation. Drivers must be care
-
ful when backing up, even when using RCP.
Alw
ays check carefully behind your vehicle,
look behind you, and be sure to check for
pedestrians, animals, other vehicles, obstruc
-
tions, and blind spots before backing up. Fail-
ure to do so can result in serious injury or
de
ath.
6
To Next Page
Loading...
