42 GETTING TO KNOW YOUR VEHICLE
To return the head restraint to its upward
position, lift up on the head restraint until it
locks into place.
To raise the center head restraint, lift up on the
he
ad restraint. To lower the center head
restraint, push the adjustment button, located
at the base of the head restraint, and push
down on the head restraint.
To remove the center head restraint, raise it as
fa
r as it can go. Then, push the adjustment
button and the release button at the base of
each post while pulling the head restraint up.
To reinstall the head restraint, put the head
re
straint posts into the holes and push
downward. Then, adjust it to the appropriate
height using the adjustment button. For
information on child seat tether routing, see
Ú page 321.
NOTE:
Lower the center head restraint to avoid contact
w
i
th the center console when folding the seat
down.
UCONNECT VOICE RECOGNITION
INTRODUCING VOICE RECOGNITION
Start using Uconnect Voice Recognition with
these helpful quick tips. It provides the key Voice
Commands and tips you need to know to control
your vehicle’s Voice Recognition (VR) system.
Uconnect 3 with 5-inch Display
Uconnect 4 With 7-inch Display
WARNING!
Do not drive the vehicle without the rear
seat head restraints installed while passen-
gers are occupying the rear seat. In a colli-
sion, people riding in this area without the
he
ad restraints installed are more likely to
be seriously injured or killed.
A loose head restraint thrown forward in a
collision or hard stop could cause serious
injury or death to occupants of the vehicle.
Always securely stow removed head
restraints in a location outside the occu-
pant compartment.
ALL the head restraints MUST be rein-
stalled in the vehicle to properly protect the
oc
cupants. Follow the reinstallation instruc-
tions above prior to operating the vehicle or
oc
cupying a seat.
To Next Page
Loading...
