Jeep Gladiator 2021 - Normal Starting; Autopark

140 STARTING AND OPERATING
NORMAL STARTING
To Turn On The Engine Using The ENGINE
START/STOP Button
1. The transmission must be in PARK or
N
EUTRAL.
2. Press and hold the brake pedal while
p
ushing the ENGINE START/STOP button
once.
3. The system starts the vehicle. If the vehicle
f
ails to start, the starter will disengage
automatically after 10 seconds.
4. If you wish to stop the cranking of the
e
ngine prior to the engine starting, push the
ENGINE START/STOP button again.
To Turn Off The Engine Using ENGINE START/
ST
OP Button
1. Place the gear selector in PARK, then push
a
nd release the ENGINE START/STOP
button. The ignition will return to the OFF
mode.
2. If the gear selector is not in PARK (with
v
ehicle stopped) and the ENGINE START/
STOP button is pushed once, the
transmission will automatically select PARK
and the engine will turn off, however the
ignition will remain in the ACC mode (NOT
the OFF mode). Never leave a vehicle out of
the PARK position, or it could roll.
3. If the gear selector is in NEUTRAL, and the
v
ehicle speed is below 5 mph (8 km/h),
pu
shing the ENGINE START/STOP button
once will turn the engine off. The ignition will
remain in the ACC mode.
4. If the vehicle speed is above 5
mph (8 km/h),
th e ENGINE START/STOP button must be
held for two seconds (or three short pushes
in a row) to turn the engine off. The ignition
will remain in the ACC mode (NOT the OFF
mode) if the engine is turned off when the
transmission is not in PARK.
NOTE:
The system will automatically time out and the
ig
nition will cycle to the OFF mode after
30
minutes of inactivity if the ignition is left in
th
e ACC or RUN (engine not running) mode and
the transmission is in PARK.
ENGINE START/STOP Button Functions — With
Dr
iver’s Foot Off The Brake Pedal (In PARK Or
NEUTRAL Position)
The ENGINE START/STOP button operates
si
milar to an ignition switch. It has three modes:
OFF, ACC, and RUN. To change the ignition
modes without starting the vehicle and use the
accessories, follow these steps:
1. Starting with the ignition in the OFF mode.
2
. Push the ENGINE START/STOP button once
t
o place the ignition to the ACC mode
(instrument cluster will display “ACC”).
3. Push the ENGINE START/STOP button a
s
econd time to place the ignition to the RUN
mode (instrument cluster will display “ON/
RUN”).
4. Push the ENGINE START/STOP button a
t
hird time to return the ignition to the OFF
mode (instrument cluster will display
“OFF”).
AUTOPARK
AutoPark is a supplemental feature to assist in
placing the vehicle in PARK should the
situations on the following pages occur. It is a