GETTING TO KNOW YOUR VEHICLE 57
NOTE:
Bi-Level mode is designed under comfort condi-
tions to provide cooler air out of the panel
o
u
tlets and warmer air from the floor outlets.
Floor Mode
Air comes from the floor outlets. A
slight amount of air is directed
th
rough the defrost and side window
demister outlets.
Mix Mode
Air is directed through the floor,
defrost, and side window demister
ou
tlets. This setting works best in cold
or snowy conditions that require extra
heat to the windshield. This setting is good for
maintaining comfort while reducing moisture on
the windshield.
Climate Control OFF Button
Press and release this button on the
touchscreen, or push and release the
bu
tton on the blower knob to turn the
Climate Control ON/OFF.
MANUAL CLIMATE CONTROL
D
ESCRIPTIONS AND FUNCTIONS
Uconnect 4 With 7-inch Display Manual Climate
Controls
MAX A/C Setting
Set the temperature control knob to
the MAX A/C setting to change the
cu
rrent setting to the coldest output
of air. Moving the temperature control
knob away from the MAX A/C setting causes the
MAX A/C operation to exit.
A/C Button
Push the A/C button to engage the Air
Conditioning (A/C). The A/C indicator
il
luminates when A/C is on.
NOTE:
For Manual Climate Controls, if the system is
in Mix, Floor or Defrost Mode, the A/C can be
turned off, but the A/C system shall remain
active to prevent fogging of the windows.
If fog or mist appears on the windshield or
side glass, select Defrost mode, and increase
blower speed if needed.
If your air conditioning performance seems
lower than expected, check the front of the
A/C condenser (located in front of the radi-
ator), for an accumulation of dirt or insects.
Cle
an with a gentle water spray from the front
of the radiator and through the condenser.
Recirculation Button
Push the Recirculation button on the
faceplate to change the system
be
tween recirculation mode and
outside air mode. The Recirculation
indicator and the A/C indicator (if equipped)
illuminate when the Recirculation button is
pressed. Recirculation can be used when
outside conditions such as smoke, odors, dust,
or high humidity are present. Recirculation can
be used in all modes except for Defrost.
Recirculation may be unavailable if conditions
2
To Next Page
Loading...
