20 GETTING TO KNOW YOUR VEHICLE
All of the key fobs provided with your new
vehicle have been programmed to the vehicle
electronics
Ú page 466.
IGNITION SWITCH
KEYLESS ENTER-N-GO — IGNITION
This feature allows the driver to operate the
ignition switch with the push of a START/STOP
ignition button as long as the key fob is in the
passenger compartment.
The START/STOP ignition button has several
op
erating modes that are labeled and will
illuminate when in position. These modes are
OFF, ACC, RUN, and START.
START/STOP Ignition Button
The push button ignition can be placed in the
fo
llowing modes:
OFF
The engine is stopped.
Some electrical devices (e.g. automatic
locking, alarm, etc.) are available.
ACC
Engine is not started.
Some electrical devices are available.
RUN
Driving position.
All electrical devices are available.
START
The engine will start.
NOTE:
In case the ignition switch does not change with
th
e push of the START/STOP ignition button, the
key fob may have a low or depleted battery. In
this situation, a backup method can be used to
operate the ignition switch. Put the nose side of
the key fob (side with the mechanical flip key)
against the START/STOP ignition button and
push to operate the ignition switch.
CAUTION!
The Sentry Key Immobilizer system is not
compatible with some aftermarket remote
starting systems. Use of these systems may
result in vehicle starting problems and loss of
security protection.
1 — OFF
2 — ACC
3 — RUN
CAUTION!
Do not use the Mechanical Key against the
START/STOP ignition button.
Do not use sharp metal objects (e.g. screw
driver etc.) to pry the button out of the igni-
tion switch. This button comes as an
as
sembly, and is not removable. This can
damage the silicone shield.
To Next Page
Loading...
