GETTING TO KNOW YOUR VEHICLE 73
(Continued)
this limit, as will most power tools. The indicator
light on the power inverter switch will be
illuminated when the inverter is turned on.
Power Inverter Switch (If Equipped)
Exterior Truck Bed Power Inverter (If Equipped)
NOTE:
400 W is the maximum for the inverter, not
ea
ch outlet. If two outlets are in use, 400 W is
shared amongst the devices plugged in.
The power inverter is designed with built-in
ov
erload protection. If the power rating of
400 W is exceeded, the power inverter
a
u
tomatically shuts down. Once the electrical
device has been removed from the outlet, the
inverter should automatically reset.
NOTE:
The Power Inverter will only turn on if the igni-
tion is in the ACC or ON/RUN position.
Due to built-in overload protection, the power
inverter will turn off if the power rating is
exceeded.
AUXILIARY SWITCHES — IF EQUIPPED
Four auxiliary switches are located in the lower
switch bank of the instrument panel and can be
used to power various electrical devices.
The functionality of the auxiliary switches can
be
changed via the Uconnect settings. All
switches can be configured for setting the
switch type operation to latching or momentary,
power source of either battery or ignition, and
ability to hold last state across key cycles.
Auxiliary Switches
WARNING!
To avoid serious injury or death:
Do not insert any objects into the recepta-
cles.
Do not touch with wet hands.
Close the lid when not in use.
If this outlet is mishandled, it may cause an
electric shock and failure.
WARNING! (Continued)
2
To Next Page
Loading...
