GETTING TO KNOW YOUR VEHICLE 41
Front Head Restraints
To raise the head restraint, pull upward on the
head restraint. To lower the head restraint,
push the adjustment button located on the
base of the head restraint, and push downward
on the head restraint. The release button does
not need to be pushed to adjust the head
restraint.
To remove the head restraint, raise it as far as it
ca
n go, then push the adjustment button and
the release button at the base of each post
while pulling the head restraint up. To reinstall
the head restraint, put the head restraint posts
into the holes and push downward. Then adjust
it to the appropriate height.
Front Head Restraint
NOTE:
Do not reposition the head restraint 180 degrees
to
the incorrect position in an attempt to gain
additional clearance to the back of the head.
Rear Head Restraints
The rear seat is equipped with nonadjustable,
but foldable, outboard head restraints, as well
as an adjustable, removable center head
restraint.
To fold down the outboard head restraints, push
th
e button located on the outboard side of the
head restraint.
Rear Foldable Outboard Head Restraints
Head restraints should never be adjusted
while the vehicle is in motion. Driving a
vehicle with the head restraints improperly
adjusted or removed could cause serious
injury or death in the event of a collision.
WARNING! (Continued)
1 — Release Button
2 — Adjustment Button
WARNING!
A loose head restraint thrown forward in a
collision or hard stop could cause serious
injury or death to occupants of the vehicle.
Always securely stow removed head
restraints in a location outside the occu-
pant compartment.
ALL the head restraints MUST be rein-
stalled in the vehicle to properly protect the
oc
cupants. Follow the reinstallation instruc-
tions above prior to operating the vehicle or
oc
cupying a seat.
2
To Next Page
Loading...
