GETTING TO KNOW YOUR VEHICLE 95
5. Remove the Torx head fasteners that
secure the hard top to the vehicle: two along
the interior bodyside, rearward of the back
doors, followed by the four fasteners along
the back of the vehicle cab using the
#T50
Torx head driver.
Step Five
6. Lo
cate the wire harness on the left rear
i
nside corner of the vehicle. To access the
harness, remove the plastic cover by
pushing the cover to the side, and sliding it
off.
NOTE:
Do not force open; this will break the plastic
co
ver.
Step Six
7. To release the wire harness, pull back on
t
he red latch (1), then push down on the
black button (2) while pulling the harness
out.
Step Seven
8. Remove the hard top from the vehicle.
I
nstall the provided edge protectors along
the bottom edges of the hard top, and place
the hard top on a soft surface to prevent
damage.
1 — Bodyside Torx Head Fasteners
2 — Vehicle Cab Torx Head Fasteners
1 — Red Latch
2 — Black Button
CAUTION!
The removal of the Freedom Top requires four
adults located on each corner. Failure to
follow this caution could damage the
Freedom Top.
2
To Next Page
Loading...
