194 STARTING AND OPERATING
PARK, the ignition is placed in the OFF position,
or the touchscreen button “X” to disable display
of the Rear View Camera image is pressed.
Whenever the Rear View Camera image is
ac
tivated through the "Back up Camera" button
in the "Controls" menu, and the vehicle speed is
greater than, or equal to 8
mph (13 km/h), a
di
splay timer for the image is initiated. The
image will continue to be displayed until the
display timer exceeds 10 seconds.
NOTE:
If the vehicle speed remains below 8 mph
(1 3 km/h), the Rear View Camera image will
be
displayed continuously until deactivated
via the touchscreen button "X", the transmis-
sion is shifted into PARK, or the ignition is
pl
aced in the OFF position.
The touchscreen button "X" to disable display
of the camera image is made available ONLY
when the vehicle is not in REVERSE.
When enabled, active guidelines are overlaid on
th
e image to illustrate the width of the vehicle
and its projected backup path based on the
steering wheel position. A dashed center line
overlay indicates the center of the vehicle to
assist with parking or aligning to a hitch/receiver.
Different colored zones indicate the distance to
th
e rear of the vehicle.
The following table shows the approximate
di
stances for each zone:
NOTE:
If snow, ice, mud, or any foreign substance
bu
ilds up on the camera lens, clean the lens,
rinse with water, and dry with a soft cloth. Do
not cover the lens.
Zoom View
When the Rear View Camera image is being
di
splayed, and the vehicle speed is below
8
mph (13 km/h) while in any gear, Zoom View
is
available. By pressing the “magnifying glass”
icon in the upper left of the display screen, the
image will zoom in to four times the standard
Zone
Distance To The Rear
Of
The Vehicle
Red 0 - 1 ft (0 - 30 cm)
Yellow
1 ft - 6.5 ft
(3
0 cm - 2 m)
Green
6.5 ft or greater
(
2
m or greater)
WARNING!
Drivers must be careful when backing up
even when using the ParkView Rear Back Up
Camera. Always check carefully behind your
vehicle, and be sure to check for pedestrians,
animals, other vehicles, obstructions, or blind
spots before backing up. You are responsible
for the safety of your surroundings and must
continue to pay attention while backing up.
Failure to do so can result in serious injury or
death.
CAUTION!
To avoid vehicle damage, ParkView should
only be used as a parking aid. The ParkView
camera is unable to view every obstacle or
object in your drive path.
To avoid vehicle damage, the vehicle must
be driven slowly when using ParkView to be
able to stop in time when an obstacle is
seen. It is recommended that the driver
look frequently over his/her shoulder when
using ParkView.
To Next Page
Loading...
