MULTIMEDIA 253
Source Select/Select Source button and then
selecting USB 1 or 2 (if equipped) or by pushing
the MEDIA button on the faceplate and then
selecting the USB button.
On the Uconnect 3 With 5-inch Display, if you
in
sert a USB device with the ignition ON/RUN,
the unit will switch to USB Mode and begin to
play. The display will show the track number and
index time in minutes and seconds. Play will
begin at the start of track 1.
Bluetooth® Mode
Overview
Bluetooth® Streaming Audio or Bluetooth®
Mo
de is entered by pairing a Bluetooth®
device, containing music, to the Uconnect
system.
Before proceeding, the Bluetooth® device must
be
paired to the Uconnect Phone to
communicate with the Uconnect system.
On the Uconnect 3 With 5-inch Display, push the
Me
dia button located on the faceplate. Once in
Media Mode, press the Source button on the
touchscreen and select the Bluetooth® button
Ú page 255.
To access Bluetooth® Mode, press the
Bl
uetooth® button on the left side of the
touchscreen or under the Source Select/Select
Source button (if equipped).
Uconnect 4 With 7-inch Display Select Source
AUX Mode
Overview
Auxiliary Mode (AUX) is entered by inserting an
AU
X device using a cable with a 3.5 mm audio
ja
ck into the AUX port or by pressing the AUX
button on the left side of the touchscreen, or
under the Source Select button (if equipped) or
pushing the Media button on the faceplate and
then selecting the Source button and then the
AUX button.
To insert an Auxiliary device, gently insert the
Au
xiliary device cable into the AUX port. If you
insert an Auxiliary device with the ignition and
the radio on, the unit will switch to AUX Mode
and begin to play.
Controlling The Auxiliary Device
The control of the Auxiliary device (e.g.,
se
lecting playlists, play, fast forward, etc.)
cannot be provided by the radio; use the device
controls instead. Adjust the volume with the
Volume button, Volume/Mute rotary knob, or
the On/Off rotary knob, or with the volume of
the attached device.
NOTE:
The radio unit is acting as the amplifier for audio
ou
tput from the Auxiliary device. Therefore, if
the volume control on the Auxiliary device is set
too low, there will be insufficient audio signal for
the radio unit to play the music on the device.
Seek Up /Seek Down
In USB Mode, press the Seek Up button on the
to
uchscreen for the next selection on the USB
device. Press and release the Seek Down
button on the touchscreen to return to the
beginning of the current selection, or to return
5
To Next Page
Loading...
