32 GETTING TO KNOW YOUR VEHICLE
4. Pull up on the red locking tab to unlock the
wiring harness.
Closed Wiring Harness
5. Push and hold down the black security tab
u
nder the wiring harness, and lift the
harness lever into the open position.
Open Wiring Harness
6. With the wiring harness open, pull
d
ownward on the wiring connector to
unplug. Unhook the wire harness strap from
the hook on the bodyside door opening.
Store the wiring connector in the lower door
basket of the door.
7. With the door in the open position, remove
t
he check bolt from the door check
attachment on the bodyside (using a
#T40
Torx head driver).
NOTE:
Keep the check arm in the extended position for
ea
sier re-installation.
Door Check
8. With the door open, lift the door with the
h
elp of another person, to clear the hinge
pins from their hinges and remove the door.
To reinstall the door(s), perform the previous
st
eps in the reverse order.
NOTE:
The upper hinge has a longer pin, which can be
u
s
ed to assist in guiding the door into place
when reinstalling. When reinstalling the door
check arm attachment bolt, bolt torque should
be between 11.76
ft·lb / 16 N·m and 27.9 ft·lb /
38
N·m.
1 — Locking Tab
2 — Wiring Harness Lever
1 — Wiring Harness Lever
2 — Black Security Tab
To Next Page
Loading...
