34 GETTING TO KNOW YOUR VEHICLE
3. Slide the front seat(s) fully forward.
4. Pry open and remove the plastic wiring
a
ccess door from the bottom of the B-pillar.
Wiring Access Door
5. Unplug the wiring connector.
N
OTE:
Squeeze the tab on the base of the wiring
ha
rness. This will unlock the connector tab,
allowing the wiring connector to be unplugged.
Unhook the wire harness strap from the hook on
the bodyside door opening. Store the wire
connector in the lower basket of the door.
Wiring Connector
6. W
ith the door in the open position, remove
t
he check bolt from the door check
attachment on the bodyside (using a #T40
Torx head driver).
NOTE:
Keep the check arm in the extended position for
ea
sier reinstallation.
Door Check
7. W
ith the door open, lift the door with the
h
elp of another person, to clear the hinge
pins from their hinges and remove the door.
To reinstall the door(s), perform the previous
st
eps in the reverse order.
NOTE:
The upper hinge has a longer pin, which can be
u
s
ed to assist in guiding the door into place
when reinstalling. When reinstalling the check
arm attachment bolt, bolt torque should be
between 11.76
ft·lb / 16 N·m and 27.9 ft·lb /
38
N·m.
To Next Page
Loading...
