7. Advance the throttle control channel to maximum. Press Select Menu or the LED
I/O board switch again, to store the R/C system’s pulse width for the turbine full
power position. The yellow Standby LED will turn off and the green OK LED will
illuminate again, indicating that the turbine full power data has been set correctly.
This completes the learn mode for throttle and initiates the learn mode for the three-
position AUX channel.
8. ECU Version 5.10E will ask for the 3 positions for the AUX switch which will allow 3
different head speeds. It will automatically set up the 3 options on R0, R1 and R2.
See page 50 for full details on this set up. Right now, you need to have a 3 position
switch set to give 3 different servo positions eg, for normal, idle up 1 and idle up 2.
Connect the Aux wire to the receiver output which is activated by this switch.
9. Once this is done the ECU will revert to Run mode and is ready for use after inputting
gear ratios and head speed selections as described on page 50
36
To Next Page
Loading...
Need help?
General
