JJRC X7 - Remote Controller Setup and Charging; TF Card Installation

a.Expand the antenna to each side
b.Insert the bracket into the slot on the back of the remote controller
Indicator Light
Green light flashing(charging)
Green light turns solid(charging completed)
Household power socketUSB adapter
USB charging cable
c.Mount the phone to the phone holder
d.Adjust the phone and antenna until the phone is fixedly mounted
Insert TF card into card slot
11
X7
Operation Manual
2. Remote controller preparation (If using the APP, please skip this step)
1) Before ying, please follow these steps to get the remote controller ready for ight
2) Battery charging for remote controller
Long press power button on remote controller to turn on the remote controller.The indicator light turns solid green when the battery
level is high, and turns ashing green when the battery level is low. When at a low battery level, please recharge the battery in
compliance with the following steps:
Warning:Disconnect the charging cable while using the remote controller.
3. Insert TF card
Caution: Do not install or remove the TF card when aircraft is powered on, otherwise, the data storage will be
affected.