Turn off aircraft:short press,then
long press over 3 seconds
Turn off RC
Forward
Left Right
Forward/Backward
Backward
18
X7
Operation Manual
Note: As for the return to home point as precise as possible, please ensure the GPS positioning function has
been turned on to record the aircraft's position before its takeoff and choose an area with no obstacles.
With the GPS positioning mode turned on, it will automatically enter auto return to home mode if the remote
controller loses control.
Once the auto return to home mode is enabled, if the aircraft flies below 30 meters of altitude, the aircraft
will automatically ascend to 30 meters before returning to home point. However, if the aircraft flies over 30
meters of altitude, the aircraft will return to home point at the current altitude. Please do not control other
functions during the process of return. Please ensure there are no obstacles in way of return in case of any
potential accidents.
After the aircraft lands and the propellers stop rotating, long press the power switch for over 2 seconds to turn off the aircraft and
the remote controller.
Caution:Please stay away from aircraft until propellers stop rotating completely.
7. Remove the battery and store it separately
(1) When nishing ight,please remove the batteries from the aircraft and remote controller and store them separately.
(2) Keep batteries out of the reach of children. Keep the battery dry. DO NOT leave the battery near heat sources such as a furnace
or heater. The ideal storage temperature is 22
℃
-28
℃
.
(3) If a battery is found to be damaged,please discharge the battery and dispose them properly according to the local regulations
and laws.
8. Pair aircraft with RC
The aircraft has already paired with the remote controller by default. If the remote controller has been replaced with a new one,
please pair again complying with the following steps:
To Next Page
Loading...
