JLG 260MRT - Preventive Maintenance and Safety Inspection

SECTION 2 - PROCEDURES
2-44 3121801
Table 2-13. Preventive Maintenance and Safety Inspection
AREA Inspections
Pre-Delivery
1
or Frequent
2
Inspection (Quarterly)
Annual
3
(Yearly)
Inspection
Scissor Arms
Scissor Arms 1,2 1,2
Safety Prop 1,2 1,2
Nuts, Bolts, Shafts, Shields, Bearings and Locking Devices 1,2 1,2
Cylinder/pivot Pins and Attaching Hardware 1,2 1,2
Platform Assembly
Platform 1 1
Mandrill Chain/Gate, Bar and Latches 1,3 1,3
Extend Deck and Locks 1,3 1,3
Guard Rails and Floor 1,2 1,2
Pl at for m R oll Pi ns a nd Fo ld Dow n R ai ls 1 1
Lanyard Anchorage Point 1,2,6 1,2,6
Chassis Assembly
Wheel Rim Nuts
1
50
1
50
Tires 1,2 1,2
Oscillating Axle and Lock Nut 3 3
Steer, Drive and Axle Components 1,2,3 1,2,3
Levelling Jacks and Stabilizers 3 3
Hydraulic Tray, Battery, Engine Compartment Covers 1,3 1,3
Outriggers/Stabilizers 3 3
Static Strap 1 1
Pot Hole Protection System 1,2,3 1,2,3
Side-Compartment Door Installation 1,3,5 1,3,5
Drive Motors 1,4,5 1,4,5
Platform Ladder 1,5 1,5
Drive Brakes 1,5 1,5
Drive Hubs 1,5 1,5
Engine Mounts 1 1
Engine Oil 3 3
Exhaust System 1,3 1,3
Sliding Wear Pads** 1,2,5,7 1,2,5,7
Fuel Tank 1,4 1,4
Function/Controls
Control Levers, Switches, Gauges and Instruments 3,5 3,5
Detents Properly Lock, Control Enclosure and Protective Boots/Guards 1,3 1,3
Emergency Stop Switches at Ground and Platform 3 3
Lift, Drive Aand Speed Cut-Outs 3 3
Auxiliary Power System 3 3
Function Enable System 3 3