Jntech JNP2K2L-V5 - Page 61

61
information, statistical information, and fault information.
8.3.1.1 operation information
The items in the operation information show the current operation information
of the inverter. The following table explains each item in detail.
Figure8-3 The meaning of main interface parameters
RunInfo
Introduction
Vdc
Inverter input voltage (V).
Ipv
Inverter input current (A).
Ppv
Inverter input power (W).
Vgrid
Inverter current Grid input voltage (V)
Pgrid
Inverter current Grid input power (W)
State_AC
Inverter current Grid input situation
Fout
Inverter output current frequency (Hz).
Iu
Inverter output U phase current (A).
Iv
Inverter output V phase current (A).
Iw
Inverter output W phase current (A).
Temp
Inverter radiator’s temperature(℃ ).
ErrCode
Inverter current fault mode.
StopCode
Stop code, can check the reason of inverter shut down most
recently.
S-Mode
Start and stop mode.
D-Mode
Protection mode against well dry out.
OF-F
Water overflow alarm function optional in Solar pump system
storage device.
Run/Stop
run /stop status.
GPRS
The connecting situation of inverter ’s GPRS.
ESC
Return to the previous menu.