Jntech JNP2K2L-V5 - Page 71

71
Password set
Description
Note
New
Password
Set the password to enter the
Settings menu.
The default initial value for a
two-digit password is 00, and
the maximum value can be set
to 99.
8.3.2.8. Language Setting
Language setting, to set the man-machine interface language category.
Table 8-15 Language set descri
Language
set
Description
Note
Chinese
After confirming the setting, the LCD display
language of the inverter is set to Chinese.
English
After confirming the setting, the LCD display
language of the inverter is set to English.
8.3.2.9. factory data reset
Used to restore factory default configuration.
Table 8-17 Restore factory Settings setting instructions
Restore factory Settings
information
Description
Note
factory data reset
After confirmation, select "Yes"
or "No" to resume factory
Settings