1. Enter the correct password to
enter the setting menu, and the
cursor falls on the timed
downtime item;
2. Press to select the
setting item of D-power;
3. After entering the D-power
setting, set the D-power
according to the confirmation;
4. Press the up key or down key
to switch the power size of
drying and modify the step size
to 100W;
5. Select the power to be set and
confirm again whether to replace
the power after confirmation;
6. Select "Yes" and set the dry
power, as shown in the left
picture. Set the D-power from 0
to 300W;
7. Press and to
To Next Page
Loading...
