The Equipment named above is confirmed to comply with the requirements set out in the European
Council Directive on the Approximation of the Laws of the Member States relating to 2014/53/EU
(RED). The equipment passed the following test which was performed according to the following
European standards:
• EN 300 328 V2.1.1
• EN 301 489-1 V2.2.0
• EN 301 489-17 V3.2.0
• EN 62311: 2008
Important: Use this FW-28 controller only as an operating control. Where failure or
malfunction of the FW-28 could lead to personal injury or property damage to the controlled
equipment or other property, additional precautions must be designed into the control
system. Incorporate and maintain other devices, such as supervisory or alarm systems or
safety or limit controls, intended to warn of or protect against failure or malfunction of the
FW-28.
Product warranty
This product is covered by a limited warranty, details of which can be found at
www.johnsoncontrols.com/buildingswarranty.
Contact information
Contact your local branch office: www.johnsoncontrols.com/locations
Contact Johnson Controls: www.johnsoncontrols.com/contact-us
Patents
Patents: https://jcipat.com
Single point of contact
APAC EU UK NA/SA
JOHNSON CONTROLS
C/O CONTROLS PRODUCT MANAGEMENT
NO. 32 CHANGJIANG RD NEW DISTRICT
WUXI JIANGSU PROVINCE 214028
CHINA
JOHNSON CONTROLS
VOLTAWEG 20
6101 XK ECHT
THE NETHERLANDS
JOHNSON CONTROLS
TYCO PARK
GRIMSHAW LANE
MANCHESTER
M40 2WL
UNITED KINGDOM
JOHNSON CONTROLS
5757 N GREEN BAY AVE.
GLENDALE, WI 53209
USA
© 2021 Johnson Controls. All rights reserved. All specifications and other information shown were current as of
document revision and are subject to change without notice.
To Previous Page
Loading...
Need help?
General
